What we install and where it connects
Most installation calls are one of a few jobs. A new bathroom or half bath, a kitchen sink or dishwasher in a remodeled room, a basement bar or laundry hookup, or an outdoor hose bib.
Each one needs a water supply, a drain sized for the fixture and a vent so the drain can flow. We check all three at the location you picked, because the best spot on a floor plan is not always where the pipes can reach.
Typical installation jobs we take on
- Bathroom and half bath rough-insSupply, drain and vent lines run to the planned toilet, vanity and tub or shower before walls close.
- Kitchen and laundry connectionsSink, dishwasher, ice maker and washer hookups with shutoff valves, a proper trap and a code-sized drain.
- Basement fixturesFloor drains, utility sinks and basement baths, including where an ejector pit is needed to lift waste up to the main drain.
- Outdoor and utility linesFrost-resistant hose bibs and shutoff valves placed where they can be drained for winter.
- Appliance suppliesWater lines for a new refrigerator, humidifier or water treatment unit, with the shutoff within reach.
Plan the pipes before the cabinets arrive
Installation goes smoothly when the plumbing is decided before finish materials are ordered. Here is what to settle first.
| Question to answer | Why it matters | Who usually decides |
|---|---|---|
| Where does the drain run to? | Waste lines need slope, and a fixture below the main drain may need a pump. | Plumber, after seeing the basement. |
| Is the supply line big enough? | Adding a bath to a small old line can drop pressure everywhere. | Plumber, with a pressure test. |
| Which fixtures are you buying? | Rough-in dimensions differ by model, so specs are needed first. | You, then confirmed with us. |
| Is a permit needed? | Scope decides whether the city requires one. | Ask the Maple Heights Building Department. |
Remodel on the calendar?
Call before the walls are opened. A short visit now saves a change order later.
Gas line installation: what a plumber can and cannot do
Gas piping for a range, dryer, fireplace or grill has to be done by the right licensed trade, and the work usually needs a city permit and inspection where it applies. We will tell you honestly whether a gas job fits our scope or needs a gas-licensed contractor.
What we can do is plan around it. We check clearances to your water and drain lines and help you decide what to do first so the gas contractor is not working around open plumbing. For permit questions, ask the Maple Heights Building Department before work is scheduled.
If you smell gas
Leave the house, do not use switches or phones inside, and call your gas utility or 911 from outside. Gas smells are never a wait-for-the-appointment problem.
Water meter installation and the piping around it
The meter itself belongs to your water utility, so a new service or meter change is arranged with them. In Maple Heights that is Cleveland Water. Cleveland Water's guidance is that the customer is responsible from the curb stop inward, including the line to the meter and frozen meters.
That is where we come in. We can replace the shutoff valves on either side of a meter, add a proper meter setting and bypass where the utility allows it, and repair the pipe feeding it. We will not install or swap the meter without the utility's say, and we will tell you who to call.
Signs your existing pipes cannot take the new load
Adding a fixture asks more of pipes that were sized decades ago. Look for these before you commit to a layout.
Pressure that sags when two fixtures run
A shower that fades when the dishwasher starts points to narrow or rusted supply pipe.
Slow main drain
New fixtures add flow to a line that already drains slowly, and the problem gets worse after the remodel.
Mixed pipe materials
Copper joined to galvanized steel corrodes at the connection and often needs updating at the tie-in.
No shutoff valves under fixtures
Older homes often lack them, and adding them is part of a good installation.
Maple Heights housing and the digging question
Survey data puts the median year built in Maple Heights at 1956, and about 68 percent of homes predate 1960. That matters for installation because tie-ins land on pipe that is often steel or early copper, and a plumber should look at it before connecting new work.
If any job involves digging in the yard, such as a new outdoor line, dial 811 first. OHIO811 asks for at least two working days notice, the service is free, and homeowners can use it.
Source type: Census survey data and state call centerWhat you can do before we arrive
Mark the spot you want each fixture on the floor or wall with painter's tape. Bring the model number or spec sheet of anything you have already bought.
Clear access to the basement ceiling below the new room and to the main shutoff, and take photos of any plumbing already in the walls. If you are working with a general contractor, give us their number so schedules line up.
Nearby towns and related work
We take installation work in Maple Heights and in Bedford, where the city lists interior plumbing, water and sewer piping and exterior gas work among its permit items. If you want a new water heater as part of the project, see water heater installation. For tying a new bath into an old line that needs replacing, repiping may come first.
Every new fixture, line and valve we set follows the Ohio Plumbing Code, OAC 4101:3, and permits for larger installs go through the Maple Heights Building Department.
Frequently asked questions
Gas piping needs the right licensed trade and a city permit where it applies. We tell you whether a job fits our scope and coordinate around it if it does not.
The meter belongs to the utility, so Cleveland Water handles it. We do the piping and valves on your side of the meter.
It can if the supply line is small or rusted. We test pressure first and tell you if an upgrade is needed.
Ask the Maple Heights Building Department, since the scope of work decides it. Contractors must be registered with the city before a permit is issued.
Often yes, but the drain may sit below the main line and need an ejector pump. We check that before you buy fixtures.
Call our 24/7 line for urgent leaks and we send a plumber. Planned installations are scheduled during normal working hours.